| 1. Solutions to common problems of Hanwha Samsung placement machine SM series pneumatic feeders: |
| |
| 1, Samsung placement machine pneumatic feeder error message: index error |
| |
| Solution: As the cylinder did not reset within the specified time delay, check whether the material is taped, and manually rotate the material belt gear to see if it is stuck. |
| |
| 2, Samsung placement machine pneumatic feeder error message: feeder light is yellow |
| |
| Solution: The sensor cannot sense the block, adjust the cylinder stroke screw or check whether the sensor is in good condition. |
| |
| 3. Samsung placement machine pneumatic feeder error message: open error (cylinder does not move) |
| |
| Solution: if the cylinder is not working due to the failure, check whether the thimble is intact, whether the solenoid valve circuit is in good contact, check the control board, check the solenoid valve, check the cylinder, and the air supply pipeline. |
| |
| 4. Samsung placement machine pneumatic feeder error message: open error (cylinder move once) |
| |
| Solution: Replace the sensor. |
| |
| 5. Samsung placement machine pneumatic feeder error message: the feeding gear does not rotate or the speed is not sensitive |
| |
| Treatment method: Check whether there is foreign matter on the feed gear, check whether the cylinder is fixed, check whether the air pressure is normal, whether the pressure cap is sensitive, whether the cylinder is flexible, you can fine-tune the cylinder stroke, adjust the gear stroke, and clean the pressure cap And oil treatment, if there is a feeling of stuck inside the cylinder, it needs to be replaced |
| |
| 6, Samsung placement machine pneumatic feeder error message: the light does not light up |
| |
| Solution: Check the control board, re-plug or replace? Check whether the switch is in good contact |
| |
| 7, Samsung placement machine pneumatic feeder error message: often reel |
| |
| Solution: Check if there is any foreign matter in the white gear, and if there is a feeling of stuck in the manual rotation. |
| |
| 8.Samsung placement machine pneumatic feeder error message: the feeder light is green but cannot be operated |
| |
| Treatment method: check whether the thimble is intact, check the control board |
| |
| 9, Samsung placement machine pneumatic feeder error message: push the feeder gear will back a little |
| |
| Processing method: adjust the stroke screw of the gear |
| |
| 10.Samsung placement machine pneumatic feeder error message: the center position of the component outline display is offset |
| |
| Solution: The small runner on the base of the feeder is deformed by collision, and it can be repaired with tools |
